Product use:

1. Support 150MIL-300MIL SOP8 chip

2. Main purpose: chips that have been welded on the board. (The customer often tests, repairs or upgrades. If the chip is removed frequently, it is easy to damage the motherboard and chip, so the clip is convenient)

The burning clip only connects 8 wires to the chip! No additional features and effects! If it can't be used, I hope you can understand a principle problem. The 8 wires will not lead to a fundamental impact, but will be limited by the external circuit. Please look at this problem objectively and choose the burning seat! thank you!

The burning clip is used for the whole series of SOP8 pin chip packaging chips, and the wide body and narrow body are converted to DIP8 direct plug in two specifications! Multi purpose test clamp!

Applicable chip size, with foot spacing of 1.27mm and width of 150-208MIL. Support chip 24/25/26/93 series.

The circuit of the test clip is one-to-one. After the test clip is clamped to the chip, it is equivalent to converting the chip to the in-line chip for programming.

Note: When the clip is directly used for programming on the circuit board, the success of programming is directly affected by some peripheral circuits. If it is not successful, the chip must be removed before it can be burned normally. The clip only acts as a wire and has no direct impact on the programming results. The clip can also be used to burn the removed chip.

Do not force the test clamp down during operation. Open the clamp and clamp it from the left and right sides of the chip. The same is true when disassembling. You can't pull it out directly. You should first separate the clip from the left to the right, and then take out the clip, so that the tip of the clip will not be damaged.

Test the clamp type connection. Use DuPont cable to connect the clamp and adapter plate. Even if the cable is broken, broken or aged, replace the DuPont cable!